CNC Machinist II-1st and 2nd Shift

JOB SUMMARY:

CNC Machinist II is a mid-level position to perform lathe and mill tasks, continue to learn all aspects of CNC operations, the trade and, as a part of the Production Team, fill in as needed in other areas in support of manufacturing. The requirements listed below are representative of the knowledge, skills and/or abilities necessary to meet the minimum job requirements of this position. Manufacture parts within a cell with multiple machines to exacting blueprint dimensions and ensure 100%-part quality. Performs simple set-ups on both manual and CNC turning / milling machining centers. Edit CNC programs as necessary to improve the machining process and extend tool life while meeting production rates.

ESSENTIAL JOB FUNCTIONS:

• Performs simple or repeat set-ups and operates equipment to produce high quality parts (100% good pieces) within prescribed routed time to meet production demands. If standard production rates cannot be met, the operator must notify his supervisor.
• Follows documented set-up sheets according to established procedures.
• Knowledgeable in basic GD&T and its application relative to part manufacture and inspection.
• Read and understand drawings to effectively manufacture parts to close tolerances.
• Maintains equipment via established preventative maintenance schedules.
• Follows all prescribed quality procedures and inspection plans.
• Performs 1st piece inspections and monitors own work to meet process requirements including fully documenting inspections reports developed by the Quality department.
• Verifies that the inspection equipment being utilized is in calibration and performs a simple daily check against a known master to ensure the accuracy of the gage to be used.
• Maintain safe operations by identifying safety risks and adhering to safety procedures, requirements and regulations. Knowledgeable with tool / insert selection and utilizing the correct feeds and speeds for the materials being machined.
• Helps train new individuals in basic CNC operations.
• Any additional duties as assigned by supervisor.

BASIC QUALIFICATIONS:

• High school diploma or general education degree (GED)
• Two to three years CNC Milling / Turning experience in a job shop environment.
• To perform this job successfully, an individual must be able to perform each essential duty satisfactorily.

PAY TRANSPARENCY

Enpro carefully considers a wide range of compensation factors including the background, education, training, and experience required, as well as geographic considerations such as cost of labor, and applicable local and state laws. These considerations can cause offered compensation to vary. The hiring range for this position is typically $24- $30 hourly. The actual offer will be based on the individual candidate. Bonus, gainshare, and/or equity may be eligible for this position. Enpro offers a range of benefits including, but not limited to medical, dental, vision, life, 401(k) matching, and other supplemental insurance options.​

WORK ENVIRONMENT:

This specification is intended to indicate the kinds of tasks and levels of work difficulty that will be required of positions that will be given this title and shall not be construed as declaring what the specific duties and responsibilities of any position shall be. It is not intended to limit or in any way modify the right of any supervisor to assign, direct, and control the work of employees under his/her supervision. The use of a particular expression or illustration describing duties shall not be held to exclude other duties not mentioned. Ability to competently perform all the essential duties of the position, with or without reasonable accommodation, demonstrated commitment to effective customer service delivery, and the ability to work productively as a member of a team or work group are basic requirements of all positions at Technetics Group.